Table of Contents
Advertisement
2. INTRODUCTION
A
WARNING: This heat pump pool heater is an
electromechanical
machine
pressurized refrigerant gas in a sealed system. ONLY
trained and qualified service personnel are authorized to
install or service this equipment. Without proper training
and knowledge of such equipment, any attempt to install or
service the unit could result in serious injury or even death.
This manual contains important information on the use,
maintenance and troubleshooting of your new heat
pump pool heater. This unit must be properly installed,
maintained and operated for optimal performance.
This heater is an extremely efficient, economical machine
designed specifically for heating swimming pools. It is
similar in design and operation to a typical residential air
conditioning system. The unit employs a hermetic motor/
compressor operating in a refrigeration cycle to extract
heat from ambient air and deliver it to the circulating pool
water.
All heat pump pool heaters have a lower BTU/hr heating
capacity than a gas-fired or oil-fired heater for the same
pool and will have to operate more hours per day to keep
the pool at setpoint. It may operate up to 24-hours a day
at certain times. It is designed to do so. Even with long
runtime hours, it will heat the pool at less cost than other
heaters using fossil fuel.
Since evaporation is the main cause of heat loss from a
pool, keeping the pool covered whenever it is not in use will
greatly reduce the cost of keeping the pool heated. Even
during warmer weather, Raypak recommends keeping the
pool covered at night.
NOTE: 4x Hurricane tie-down brackets, 16x tie-down
screws, 2x union halves, the printed warranty, optional
harnesses and the I&O manual are located in an
accessory bag mounted on the front of the heater
inside the packaging. For Heat/Cool models, a bypass
assembly is provided. Please DO NOT throw away the
packaging before removing all of their contents.
ATTENTION: Please Take This Opportunity
to Quickly Register Your Unit!!
While your unit is being installed by your professional and
licensed installer of choice, Please Take This Opportunity to
Quickly Register Your Unit!! With the necessary information
in hand, Registering your new Heat Pump Pool Heater only
takes a few moments and is the only way to assure any
verifiable warranty procedures during the span of your unit's
period of protection.
Using Figure 1, please locate and record your model and
serial number. Once you have done this, please make sure
you also have the following information on hand:
•
Name, phone number, and email address of
homeowner
•
Physical address of where the unit is installed; please
include any 'subdivision' or similar information
that
incorporates
a
•
Any service challenges present at the house/
neighborhood: gated community, locked access at
house, guard dog, etc.
•
Date of installation of the new unit
•
Name and phone number of the professional and
licensed entity that performed the installation for you
With all of the above information in hand, please contact
Raypak and ask to register your brand new heat pump or
Online at:
https://www.raypak.com/support/registration_warranty/
You will be given a Warranty Registration Confirmation
number which you should notate and keep in one location
along with your Installation & Owner's Manual, a copy of
your warranty (provided with your manual) and the above
information.
This unit is equipped with a QR Code on the rating plate, as
shown in Figure 1, which will take you to the www.raypak.com
website where the Installation & Owner's manual and other
documents can be easily accessed.
This would also be a good time to review both the manual
and the warranty so that you are aware of how to correctly
operate your new equipment as well as how to keep from
voiding any aspects of your warranty. During the life of your
unit, please feel free to use the phone number conveniently
located right on the unit, to contact us with any questions you
may have about operation, warranty, and/or service.
Thank you very much choosing Raypak to satisfy your pool
heating needs!!
Figure 1.
Model and Serial Number Location
Warranty Registration Confirmation #:
Scan this QR with your smart device to register or verify
your new Raypak heater.
Nameplate
QR Code
5
Advertisement
Table of Contents
