Lincoln Electric 50448 Service Manual page 18

Table 9. User Setup Menu
Symbol
Preflow Time
Postflow Time
Burnback Time
Spot Welding Settings
Run-in WFS
Start Procedure
Crater Procedure
A/B Procedure
Recall from the User Memory
Save to the User Memory
USB Memory
WARNING
To change the parameters or functions value, theirs icons
has to be added to the Welding Parameters Bar [41].
To add parameter or function to the Welding Parameters
Bar [41]:
Access to the „User Setup" (see the Figure 11.)
Use the right knob [33] to highlight the parameter or
function icon which will be added to the Welding
Parameters Bar [41], for example Run-in WFS.
Figure 16
Press the right knob [33] to confirm the selection. Run-in
WFS icon will be dropped.
Description
Figure 17
WARNING
To remove the icon - press the right knob [33] once
•
again.
To exit from User Setup Menu – press the left button
•
[32].
Selected parameter or function were added to the
Welding Parameters Bar [41].
Figure 18
To remove selected parameter or function from the
Welding Parameters Bar [41]:
Access to the „User Setup".
Use the right knob [33] to highlight the parameter or
function icon which was added to the Welding
Parameters Bar [41].
Figure 19
Press the right knob [33] – selected icon will disappeared
from the display bottom.