Table of Contents
Advertisement
Advanced User Interface (U7)
31
32
Figure 7
31. Display: 7" TFT display shows welding processes
parameters.
Table 6 Standard / Advance UI Look
33
34
Figure 8
Figure 9
32. Left Knob: Sets the value in the top left corner of the
display. Cancel selection. Return to the previous menu.
33. Right Knob: Sets the value in the top right corner of the
display. Cancel selection. Confirmation of changes.
34. Button: It enables return to main menu.
User have access to the two different views of
interface:
Standard view (Figure 8.)
Advanced view (Figure 9.)
To choose the view of interface:
Press the button [34] or right knob [33].
Use the right Knob [33] to highlight the "Configuration"
icon.
Press the right knob [33] to confirm decision.
Use the right knob [33] to highlight "UI look" icon.
Press the right knob [33] to confirm decision.
Select one of the view (Standard – Figure 8. or Advanced
– Figure 9.).
Press the button [34] or left knob [32] to return to main
menu.
35. Status bar.
36. Measured value of current
37. Measured value of voltage.
38. Parameter Value (wire feed
39. Parameter
40. Visualization
41. Welding Parameters Bar.
Functions
(Figure 8 Errore.
L'origine
riferimento non
è stata
trovata. )
and
voltage
Figure 9).
speed or current) regulated
by left knob [32].
Value (voltage,
trim) regulated by right knob
[33].
of
Welding
Parameters.
Advertisement
Table of Contents
