Using The Parking Brake; Starting And Stopping The Engine - Toro Wheel Horse 520xi Operator's Manual

5
15
2
1
3
4
Figure 11
1. Throttle
2. Choke
3. PTO switch
4. Seat adjustment lever
5. Engine water temperature
gauge
6. Attachment lift lever
7. Indicator lights
8. Fuel gauge

Using the Parking Brake

Set the parking brake when you stop the machine or leave
it unattended.
Setting the Parking Brake
1. Push the brake pedal (Fig. 11) down and hold it.
2. Lift the parking brake lever (Fig. 11) up and gradually
take your foot off the brake pedal. The brake pedal
should stay down.
Releasing the Parking Brake
1. Push down on the brake pedal (Fig. 11).
The parking brake lever should release.
2. Release the brake pedal.
7
8
6
11
9
16
10
12
13
14
m–3597
9. Hour meter
10. Ignition switch
11. Brake pedal
12. Parking brake lever
13. High-Low range lever
14. Cruise control switch
15. Steering wheel tilt lever
16. Traction control pedal
13
Starting and Stopping
the Engine
Starting
1. Sit down on the seat.
2. Push the brake pedal down.
Note: The engine will not start unless you push the brake
pedal down fully.
3. Push the PTO switch to the off position (Fig. 12).
2
1
3
Figure 12
1. Throttle
2. Choke
4. Move the choke lever to the on position (if the engine
is cold) (Fig. 12).
5. Move the throttle lever halfway to the fast position
(Fig. 12).
6. Turn the ignition key clockwise and hold it in the start
position (Fig. 13).
1
Figure 13
1. Stop
2. Run with lights
7. When the engine starts, release the key.
Important Do not crank the engine continuously for
more than 10 seconds at a time. If the engine does not
start, allow a 60 second cool-down period between
starting attempts. Failure to follow these guidelines can
burn out the starter.
m–3257
3. PTO switch
2
3
4
m–3312
3. Run
4. Start