Table of Contents
Advertisement
8
XCC system management port (1 GB RJ-45)
The server has a 1 GB RJ-45 connector dedicated to Lenovo XClarity Controller (XCC) functions. Through
the system management port, you can access the Lenovo XClarity Controller directly by connecting your
laptop to the management port using an Ethernet cable. Make sure that you modify the IP settings on the
laptop so that it is on the same network as the server default settings. A dedicated management network
provides additional security by physically separating the management network traffic from the production
network.
See the following for more information:
•
"Set the network connection for the Lenovo XClarity Controller" on page 49
•
"XCC system management port LEDs" on page 37
9
VGA connector
Connect a monitor to this connector.
Serial port
10
Connect a 9-pin serial device to this connector. The serial port is shared with XCC. XCC can take control of
the shared serial port to redirect serial traffic, using Serial over LAN (SOL).
Hot-swap power supply model
The rear of the server provides access to several components, including the power supplies, PCIe adapters,
serial port, and Ethernet port.
Note: Depending on the configuration, your server might be slightly different from the image.
Figure 6. Hot-swap power supply model rear view
PCIe slot 1
1
PCIe slot 2
2
bay 1
3
bay 2
4
NMI button
5
USB 3.2 Gen 1 (5 Gbps) connectors
6
1
PCIe slot 1
Install PCIe adapters into this slot.
2
PCIe slot 2
Install PCIe adapters into this slot.
Ethernet connector 2
7
Ethernet connector 1 (shared with XCC network port)
8
XCC system management port (1 GB RJ-45)
9
VGA connector
10
Serial port
11
Chapter 2
.
Server components
21
Advertisement
Table of Contents
