User And Privilege Modes - ZyXEL Communications 1050 Cli Reference Manual

C
H A P T E R

User and Privilege Modes

This chapter describes how to use these two modes.
2.1 User And Privilege Modes
This is the mode you are in when you first log into the CLI. (Do not confuse 'user mode' with
types of user accounts the ZyWALL uses. See
about the user types. 'User' type accounts can only run 'exit' in this mode. However, they may
need to log into the device in order to be authenticated for 'user-aware' policies, for example a
firewall rule that a particular user is exempt from or a VPN tunnel that only certain people may
use.)
Type 'enable' to go to 'privilege mode'. No password is required. All commands can be run
from here except those marked with an asterisk. Many of these commands are for trouble-
shooting purposes, for example the htm (hardware test module) and debug commands.
Customer support may ask you to run some of these commands and send the results if you
need assistance troubleshooting your device.
For admin logins, all commands are visible in 'user mode' but not all can be run there. The
following table displays which commands can be run in 'user mode'. All commands can be
run in 'privilege mode'.
The htm and psm commands are for ZyXEL's internal manufacturing process.
Table 4 User (U) and Privilege (P) Mode Commands
COMMAND MODE
P
apply
U/P
atse
U/P
clear
U/P
configure
P
copy
U/P
debug (*)
P
delete
P
details
ZyWALL (ZLD) CLI Reference Guide
DESCRIPTION
Applies a configuration file.
Displays the seed code
Clears system or debug logs or DHCP binding.
Use 'configure terminal' to enter configuration mode.
Copies configuration files.
For support personnel only! The device needs to have the debug flag enabled.
Deletes configuration files.
Performs diagnostic commands.
Chapter 23 on page 171 for more information
2
29