Ssh Command Examples; Telnet Commands - ZyXEL Communications 1050 Cli Reference Manual

Table 130 Command Summary: SSH (continued)
COMMAND
[no] ip ssh server v1
no ip ssh server rule <1..32>
show ip ssh server status

33.3.4 SSH Command Examples

This command sets a service control rule that allowed the computers with the IP addresses
matching the specified address object to access the specified zone using SSH service.
Router# configure terminal
Router(config)# ip ssh server rule 2 access-group Marketing zone WAN action
accept
This command sets a certificate (Default) to be used to identify the ZyWALL.
Router# configure terminal
Router(config)# ip ssh server cert Default
33.4 Telnet
You can configure your ZyWALL for remote Telnet access.

33.5 Telnet Commands

The following table describes the commands available for Telnet. You must use the
configure terminal
commands.
Table 131 Command Summary: Telnet
COMMAND
[no] ip telnet server
[no] ip telnet server port <1..65535>
ZyWALL (ZLD) CLI Reference Guide
DESCRIPTION
Enables remote management using SSH v1. The
no
v1.
Deletes a service control rule for SSH service.
Displays SSH settings.
command to enter the configuration mode before you can use these
DESCRIPTION
Allows Telnet access to the ZyWALL CLI. The
command disables Telnet access to the ZyWALL
CLI.
Sets the Telnet service port number. The
command resets the Telnet service port number
back to the factory default (23).
Chapter 33 System Remote Management
command stops the ZyWALL from using SSH
no
no
215