Table of Contents
Advertisement
12 SERVICE WORK ON THE CHASSIS
64
–
Loosen screws
–
Remove screw
A00476-11
–
Loosen and retighten screw
Guideline
Screw, top steering
head
–
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
F02402-10
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Mount and tighten screw
Guideline
Screw, top
steering stem
A00476-11
–
Position steering damper
2
screws
.
Guideline
Screw, steering
damper
–
Remove the cable ties and position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
F02433-11
rectly.
–
Position the handlebar clamps with the rubber washers and
elastomers.
–
Mount screws
Guideline
Screw, handlebar
clamp
Info
Make sure the installed gaps are even.
Finishing work
–
Check steering head bearing play. (
4
.
5
.
6
.
M20x1
12 Nm (8.9 lbf ft)
4
.
M8
15 Nm (11.1 lbf ft)
5
.
M8
20 Nm (14.8 lbf ft)
3
and mount and tighten
M6
15 Nm (11.1 lbf ft)
1
and tighten evenly.
M8
20 Nm (14.8 lbf ft)
p. 63)
Loctite
®
243™
Advertisement
Table of Contents
