Advertisement
3.
Place the circuit breakers back into the control box.
The tabs on the breakers are spring loaded and will
snap back to their locked position once the breakers
are properly seated.
Section 5. Install Heater
STEP 1 - Remove Heater Compartment Panel.
STEP 2 - Disconnect & Dispose of Pigtail Harness.
1.
Remove the screw mounted wire tie that is holding the
pigtail harness and case ground wire to the cabinet.
Remove the wire tie from the two green ground wires.
2.
Unplug and dispose of pigtail harness.
Note: If there is not a conduit plug in the top cross-
member, drill a 2" diameter hole in the top panel to
feed the wires through. Use the conduit locating
target for the location of the 2" diameter hole.
INSTALLER'S GUIDE
Field
Connections
ON
Circuit
Breaker
Assembly - Rotated
Circuit Breaker
BLACK
RED
GREEN - GROUND
Factory
Connections
Control
Box
Heater
Compartment
Panel
WIRES CIRCLE
BACK AND GO
THROUGH
SCREW MOUNTED
WIRE TIE
Page 5
Advertisement
