Wlan And Maintenance Settings; Logging In To The Web Configurator In Ap Mode - ZyXEL Communications NBG-416N User Manual

Chapter 5 AP Mode
Note: If you change the IP address of the NBG-416N in the screen below, you will
need to log into the NBG-416N again using the new IP address.
Figure 28 Network > LAN > IP
The table below describes the labels in the screen.
Table 21 Network > LAN > IP
LABEL
Get from DHCP
Server
User Defined LAN IP
IP Address
IP Subnet Mask
Apply
Reset

5.4.2 WLAN and Maintenance Settings

The configuration of wireless and maintenance settings in AP Mode is the same as
for Router Mode.
• See Chapter 5 on page 69
network.
• See Troubleshooting (145)
settings.
5.5 Logging in to the Web Configurator in AP
Mode
Connect your computer to the LAN port of the NBG-416N.
1
54
DESCRIPTION
Select this to let the DHCP server in the gateway assign the NBG-
416N IP address.
Select this to give the NBG-416N a static IP address.
Type the IP address in dotted decimal notation. The default
setting is 192.168.1.2. If you change the IP address you will have
to log in again with the new IP address.
The subnet mask specifies the network number portion of an IP
address. Your NBG-416N will automatically calculate the subnet
mask based on the IP address that you assign. Unless you are
implementing subnetting, use the subnet mask computed by the
NBG-416N.
Click Apply to save your changes to the NBG-416N.
Click Reset to reload the previous configuration for this screen.
for information on the configuring your wireless
for information on configuring your maintenance
NBG-416N User's Guide