Remote Control; Push Buttons - BEA EAGLE Quick Start Manual

SETTINGS
6
Program the sensor for the desired application, using the remote control or push button options.
When mounting at the maximum height, the sensor manufacturer recommends the following:

REMOTE CONTROL

ZONE SIZE
IMMUNITY FILTER
DETECTION MODE
OUTPUT
CONFIGURATION
HOLD-OPEN TIME
MOUNTING HEIGHT
DOOR CONTROL
FACTORY RESET
Access codes (1 to 4 digits) are recommended to set sensors installed close to each other.
SAVING ACCESS CODE:
DELETE ACCESS CODE:
Once you have saved an access code, you always need to enter this code to unlock the sensor.
If you forget the access code, cycle the power. For the first minute, you can access the sensor without an
access code.

PUSH BUTTONS

ZONE SIZE
FACTORY RESET
75.5601.04 EAGLE 20240412
Immunity = low
Zone Size = XXL
XXS XS
low
bi
A
0.5 s 1.5 s
< 10 ft
auto
> 2 sec
S > >
high >
normal
uni uni MTF &
uni
MTF AWAY AWAY
P
3 s 5 s 7 s 9 s
> 10 ft
open = the sensor detects constantly. The LED is ON.
open closed
closed = the sensor is in standby and does not detect. The LED is OFF.
ACCESS CODE
+
> > L XL
> > L XL
bi = two-way detection
uni = one-way detection towards sensor
uni MTF = one-way detection with motion tracking feature
uni AWAY = one-way detection away from sensor
A = active output (NO-contact); relay energizes upon detection
P = passive output (NC-contact); relay de-energizes upon detection
10 s 15 s 20 s
FACTORY VALUES
XXL
highest
30 s
reset
Page 5 of 8