Remote Control Setup - BEA IRIS Setup Manual

4
IR presence sensing field: select the applicable IR lens – narrow or wide (default)
2 curtains of 24 overlapping spots
5
IR presence sensing field : Adjust the infrared curtain as shown below.
For automatic sliding doors the curtain should reach within 3" of the face of the sliding door panel.
When mounting one sensor on each side of the door above a highly reflective threshold, select different frequencies
to avoid crosstalk between the sensors.
4 Remote Control Set-up
1
Important User Guide Symbols
LED display during normal function
RED LED
ORANGE LED
75.5159.09 20090115
(no holes between spots)
Above 10' mounting height, use the narrow prism!
The pin shown
here above
indicates the
angle adjusted.
Keep a minimum distance of 2"
 between the door and the first
curtain.
LED turns on LED flashing slowly
Presence detection
See chapter 7: Troubleshooting
2 curtains of 12 overlapping spots
(no holes between spots)
+4° -4°
0°
To approach the
curtain to the
door, turn the
screw clockwise.
To tilt the curtain
out, turn the screw
counterclockwise.
LED flashing quickly
Install the applicable lens into the slots
at bottom side of sensor.
The default lens is wide.
Use the Spotfinder (accessory)
to locate and adjust the position
of the curtains.
Presence detection
4/10