ZyXEL Communications Prestige P660RU-T1 Firmware Release Notes page 20

ZyXEL Confidential
opmode
rateadap
perfdata
reset
Status
errorsecond
targetnoise
wan atm vchunt
hwsar disp
clear
Zero Status
On
Off
Flags
debug
USB Related Command
usb
340ST5C0.doc
adsl2
adsl2plus
[on|off]
sendes
[value]
Add <remoteNodeIndex> <vpi> <vci>
<service bit(hex)>
Remove <removeNodeId> <vpi> <vci>
Active <yes|no>
display
Clear
Save
timer
Send
result
<disable (1:zeroCfh / 2:auto-hunt /
4:password / 7:all)>
1:enable / 0:disable
Command
Show the operational mode
Turn on/off rate adaptive mechanism
Show performance information,CRC,FEC, error
seconds..
Reset ADSL modem, and must reload the modem
code again
ADSL status (ex: up, down or wait for init)
Send current error second information
immediately
Adjust target noise offset
Add a entry to hunting pool
<remote node> : input the remote node index 1-8
<vpi> : vpi value
<vci> : vci value
<service>: it's a hex value, bit0:PPPoE/VC (1),
bit1:PPPoE/LLC (2) , bit2:PPPoA/VC (4),
bit3:PPPoA/LLC (8), bit4:Enet/VC (16),
bit5 :Enet/LLC (32)
For examples:
If you need service PPPoE/LLC and Enet/LLC
then the service bits will be 2+32 = 34 (decimal)
= 22 (hex), you must input 22
Need to perform save after this command
Input remote node ID and vpi, vci value to
remove the specific entry. System will save
automatically.
Enable VC auto hunting featurer
Display the hunt pool
Clear the configure buffer
Save current setting into ROM file
The waiting time before checking the hunting
table result
Send VC hunt pattern again
Check the result of VC auto hunting
Display hwsar packets incoming/outgoing
information
Clear hwsar packets information
Display status of Zero configuration
Turn on Zero configuration
Turn off Zero configuration
Display debug messages
20/25
Home
Description