ZyXEL Communications P-2302R-P1C Firmware Release Notes page 12

ZyXEL Confidential
timeinterval
defectcheck
txgain
targetnoise
maxtonelimit
rxgain
txoutputpwr
rxoutputpwr
maxoutputpwr
errorsecond
dygasprecover
dygasprecover
dygasprecover
rsploss
atm test
hwsar disp
clear
IP Related Command
ip
address
alias
aliasdis
arp
status
360AUG0C0.rtf
[mins]
[on|off]
[value]
[value]
[value]
[value]
[value]
[value]
[value]
sendes
level [value]
active [on|off|
[1|0]
[fix|rand|period|oam|loopback]
Command
[addr]
<iface>
<0|1>
<iface>
12/35
will continue to monitor the time period
ersisttime_ before doing 1 shutdown RA3_,
default is 30 seconds
when "L1 shutdown RA3" is done twice, and still
can't reach the max rate which system recorded,
it will delay a time period that the period base
time is"timeinterval" before starting again. The
time-based default is 2 hrs
Turn on/off detect table checking, default is on
Set the CTRLE register (0xc3), the value is from
0xfa to 0x06
Set the CTRLE register (0xc4), the value is from
0xfa to 0x06
Set the CTRLE register (0xc5), the value is from
0xfa to 0x06
Set the CTRLE register (0xc6), the value is from
0xfa to 0x06
Set the CTRLE register (0xc7), the value is from
0xfa to 0x06
Set the CTRLE register (0xc8), the value is from
0xfa to 0x06
Set the CTRLE register (0xc9), the value is from
0xfa to 0x06
Send current error second information
immediately
By default is 100, after receiving 100 dying gasp
system will reboot
Turn on/off this mechanism
Turn on means to response signal loss of CTRLE
immediately, default is off
Generate ATM traffic
Display hwsar packets incoming/outgoing
information
Clear hwsar packets information
Home
Description
display host ip address
alias iface
disable alias
display ip arp status