Table of Contents
Advertisement
USER'S MANUAL OF WLAN BROADBAND ROUTER
Idle Time
MTU Size
Attain DNS
Automatically
Set DNS Manually
DNS 1
DNS 2
DNS 3
Clone MAC Address
Enable uPNP
Enable Web Server
Access on WAN
Enable WAN Echo
Reply
Apply Changes
Reset
connection through PPPoE protocol whenever you send
the data packets out through the WAN interface; there are
a watchdog implemented to close the PPPoE connection
while there are no data sent out longer than the idle time
set.
Manual connection type means to setup the connection
through the PPPoE protocol by clicking the Connect
button manually, and clicking the Disconnect button
manually.
If you select the PPPoE and Connect on Demand
connection type, fill in the idle time for auto-disconnect
function. Value can be between 1 and 1000 minutes.
Fill in the mtu size of MTU Size. The default value is
1400. Refer to 4.23 What is Maximum Transmission Unit
(MTU) Size?
Click to select getting DNS address for PPPoE support.
Please select Set DNS Manually if the PPPoE support is
selected.
Click to select getting DNS address for Static IP support.
Fill in the IP address of Domain Name Server 1.
Fill in the IP address of Domain Name Server 2.
Fill in the IP address of Domain Name Server 3.
Fill in the MAC address that is the MAC address to be
cloned. Refer to 4.24 What is Clone MAC Address?
Click the checkbox to enable uPNP function.
Refer to 4.22 What is Universal Plug and Play (uPNP)?
Click the checkbox to enable web configuration from
WAN side.
Click the checkbox to enable WAN ICMP response.
Click the Apply Changes button to complete the new
configuration setting.
Click the Reset button to abort change and recover the
previous configuration setting.
Version: 1.0
31
Advertisement
Table of Contents
