Power Down Mode
Select the standby behavior of the display. In all Power Down Modes, the RS232 In port
accepts commands, and CEC and Schedule features remain functional.
Options: Standby Mode, Networked Standby Mode, Wake on Signal, Always On
Default: Standby Mode
Standby Mode: Achieves the lowest standby power consumption and disables network
communications while in standby.
Networked Standby Mode: This is the same as Standby Mode but also supports
waking up the display using Wake-on-Lan (WoL).
Wake on Signal: The display will enter a standby mode if no signal is detected. When a
signal is restored, the display will quickly power on and show the image. Network
communications will remain active.
o Note: Sending an OFF command will bypass Wake On Signal detection and
enter the fast startup mode like Always On.
o Note: If Failover detection has been enabled, the display will automatically
search for a signal on other inputs before entering standby.
Always On: This is the fast startup mode. An OFF command will place the display into a
standby mode with partially reduced power and network communications still active.
Note: Startup time can be reduced by using Wake On Signal or Always On.
Advanced Settings Reset
Resets all settings in the Advanced Settings menu to their default values.
Planar Simplicity M Series User Manual
020-1429-00A
Operating the Display
Page | 66