Advertisement
SECTION 11
REASSEMBLY
Camgear
Timing Mark P.
Crankshatt
А
Timing Mark
Figure 11-16. Aligning Crankshaft and
Cam Gear Timing Marks.
4. Measure the camshaft end play with a flat feeler
gauge.
The recommended camshaft end play is
-003/.013".
Refer to Figure 11-17.
Add shim spacers, if necessary, to bring end play
within range.
n
Camshatt @
Flat Feeler
Gauge
Figure 11-17.
Measuring Camshaft End Play.
INSTALL CAMSHAFT BORE
PLUG AND SEAL CRANKCASE
1. Prepare the sealing surfaces of the crankcase
sides and mating surfaces of crankcase and cylin-
der barrels as directed by the sealant
manufacturer.
NOTE:
Do not scrape the surfaces when cleaning
as this will damage the surfaces causing
leaks. The use of a gasket removing sol-
vent is recommended.
2. Apply a 1/16" bead of sealant to the 42 crankcase
side as shown in Figure 11-18.
Follow the sea-
lant manufacturer's recommendations regarding
"setting." Recommended sealants are listed
below.
$2 Crankcase Side
©
О
Sealant
П)
n
С
Оп Gallery
\\1+—— (In #1 Side)
Sealant
Sealant
(iy
DT
TOU
Figure 11-18. Crankcase Sealant Pattern.
Advertisement
