Battery Cable; Removing The Battery Cable; Installing The Battery Cable - Dell Vostro 5515 DVC9Y Service Manual

1. Using the alignment posts, place the 4-cell battery on the palm-rest and keyboard assembly.
2. Align the screw holes on the 4-cell battery with the screw holes on the palm-rest and keyboard assembly.
3. Replace the four (M2x3) screws that secure the 4-cell battery to the palm-rest and keyboard assembly.
4. Connect the battery cable to the system board.
5. Adhere the tape that secures the battery cable to the system board.
1. Install the base cover.
2. Follow the procedure in

Battery cable

Removing the battery cable

1. Follow the procedure in
2. Remove the base cover.
3. Remove the 3-cell battery
NOTE: If battery is disconnected from system board for service, then there is a delay during system boot as the system
undergoes RTC battery reset.
The following images indicate the location of the battery cable and provide a visual representation of the removal procedure.
1. Flip the battery and remove the battery cable from the routing guides on the battery.
2. Disconnect the battery cable from the connector on the battery.
3. Lift the battery cable off the battery.

Installing the battery cable

If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of the battery cable and provides a visual representation of the installation procedure.
20 Removing and installing components
After working on your computer.
Before working inside your
or 4-cell battery, whichever applicable.
computer.