Snmp Traps Overview; Device Traps - Paradyne COMSPHERE 6700 Series User Manual

Management Information Bases

SNMP Traps Overview

COMSPHERE 6700 NMS alerts may be exported to authorized
SNMP managers as SNMP traps. Traps are forwarded for any
event that makes it through the COMSPHERE 6700 Series
NMS's alert filter.
All traps are enterprise specific, with an OBJECT IDENTIFIER
specifying the COMSPHERE 6700 Enterprise Device product.
Trap forwarding can be turned on/off for each SNMP manager in
the authorized manager list through the COMSPHERE 6700
Series NMS Network Configuration feature or via SNMP. To do
so, refer to the COMSPHERE 6700 Series Network
Management System Network Configuration Guide .
Refer to Appendix C for a full description of the COMSPHERE
6700 Enterprise Traps.

Device Traps

Device traps are generated for device-related alert conditions
detected by the COMSPHERE 6700 Series NMS.
The Enterprise OBJECT IDENTIFIER used in device traps is the
following:
iso(1) org(3) dod(6) internet(1) private(4) enterprises(1) att-2(74) att-products(1)
paradyneNMS-products(13) nms6700-products(2) devOid(2)
The community name used in device product traps is the Device
Read Community. This is formed by concatenating base read
community with the device name.
The following COMSPHERE 6700 Device MIB variable bindings
are included in each trap message.
G
Device Name (devAdminName)
G
Device Type (devAdminModelType)
G
System Time (nmsSystemTime)
Table 3-2 identifies which primary alert traps apply to the specific
devices. Trap numbers 1–32 are reserved for primary alerts.
Issue 1 September 1994
3-7