Installation; Overview; 3800 Series Modem Package; Model 3810 Or Model 3820 Modem Installation - Paradyne 3800 Supplement Manual

Overview

This chapter provides installation procedures for the Model 3810, 3820, and 3811 modems
installed in Japan.

3800 Series Modem Package

After opening the modem's package, check for damage and verify that the following items are
present:
For the standalone models
For the carrier-mounted model
If any hardware components are damaged, notify your sales representative.

Model 3810 or Model 3820 Modem Installation

The following procedures describe how to connect the standalone modem to the dial line, leased
line, and ac power transformer.
Before installing your modem, make sure your installation site is clean and well-ventilated. Allow
space around the modem for installing cables and telephone cords, and make sure the modem is
located within reach of the ac power outlet. The distance between your modem and DTE should be
minimized if DTE data rates exceed 19,200 bps. Also, low capacitance cables may be necessary
for speeds greater than 19,200 bps or distances greater than 50 feet.
Figure 2-1
certain TELCO jack types using the supplied cables.
3810-A2-GB93-20
Manual and reference card
Model 3810 or Model 3820 modem
Power transformer
One 6-position, 4-wire modular cord (Model 3810 and Model 3820)
One 8-position to 6-position crossover modular cord (Model 3810 only)
Manual and reference card
Model 3811 modem
Rear connector plate with two DB-25-P edge card connectors
and Figure 2-2 show how Model 3810 and Model 3820 modems are connected to
November 1996

Installation

2
2-1