Table of Contents
Advertisement
Manual for installation of the Sensformer® Connectivity Device
1. Legal provisions
Warning Notice Concept
This manual contains notices that you must observe in the
interests of your own personal safety and in order to avoid
damage to property. Read the manual thoroughly before use of
equipment and keep manual for further reference! The notices
relating to your personal safety are highlighted with a warning
triangle. Those relating to the prevention of damage to property
only do not have a warning triangle. The warning notices are
presented in decreasing order of severity based on the hazard
level involved.
DANGER
Death or serious personal injury will occur if the corresponding
precautionary measure is not taken.
WARNING
Death or serious personal injury will occur if the corresponding
precautionary measure is not taken.
CAUTION
Minor personal injury can occur if the corresponding
precautionary measure is not taken.
REQUIREMENT
Requirements to be observed.
NOTE
Provision of additional important information.
In cases where two or more hazard levels apply, it is always only
the warning notice for the most severe level which is used alone.
A warning notice primarily involves possible personal injury. But
it also can mean damage to property at the same time.
Qualified personnel
The product/system associated with this documentation may only
be operated by qualified personnel trained for the task
concerned, in accordance with the documentation associated
with the task concerned and in particular the safety and warning
notices contained in this document. Qualified personnel are
capable, on the basis of their training and experience, of
recognizing risks and avoiding potential hazards in their wor k with
these products/systems.
Use of System
Please give due consideration to the following:
WARNING
The Siemens Sensformer Connectivity Device may only be used
for the application it is provided for in the catalog and in
the associated documentation. Using this product in a
divergent way may have an impact on the protection
provided by the system. Proper transportation, storage,
assembly, installation, setup, commissioning, operation and
maintenance are essential for
operation of the products. The specified environmental
requirements must be met. Notices in the associated
documentation must be observed.
Trademarks
All trademarks, registered trademarks, service marks, and trade
names are the property of their respective owners.
Disclaimer of Liability
We have checked the contents of the document for compliance
with
the
discrepancies cannot be excluded and we accordingly do not
guarantee absolute compliance. The information contained in this
document is reviewed regularly and any corrections necessary are
incorporated into subsequent editions. The data and illustrations
in this document which refer explicitly to devices and equipment
from third-party providers are not obligatory. Together with our
partners or the third-party providers we reserve the right to
modify our service and products in line with our policy of
continuous service and product development. The information in
this document is subject to change without notice and should not
be construed as a commitment by Siemens Energy.
Siemens Energy assumes no responsibility for any errors that may
appear in this document. If you have any suggestions for
improvements or amendments or have found errors in this report,
please notify us. No part of this document may be reproduced in
any form or by any means, electronic or mechanical, including
photocopying, without the express written permission of Siemens
Energy. All rights reserved.
© 2020 Siemens Energy
the safe and effective
described
hardware
and
software.
However,
Page 4
Advertisement
Table of Contents
