Kenwood TM-701A Instruction Manual page 25

4-5-5. Memory Channel Scan
If you wish to scan the contents of the memory channels
use the following procedure:
1. Adjust the SQUELCH control to the threshold point.
2. Press the MR key for longer than 1 second. The MHz in-
dicator will begin flashing and the memory channel indi-
cator will indicate the memory channels that are being
scanned.
3. Scan will begin at the current memory channel and pro-
ceed upwards thru the memory channels. You can
change the direction of scan by turning the tuning con-
trol or by pressing the microphone UP/DWN switches.
Only those memory channels that have data entered into
it will be scanned.
4. Scan will stop whenever a signal is received that is capa-
ble of opening squelch.
5. To cancel scan press the PTT key or any other front panel
key.
4-5-6. Dual Scan
Dual VFO Scan Press and hold the BAND key for
longer than 1 second in the VFO
mode. Scan will proceed between
the last UHF and VHF VFO fre-
quencies.
Press and hold the BAND key for
longer than 1 second in the MR
mode. Scan will proceed between
the last UHF and VHF Memory
channels.
Dual Call channel Scan Press and hold the BAND key for
longer than 1 second in the Call
Dual MR Scan
channel mode. Scan will proceed
between the two Call channels.
To cancel Dual Scan press the PTT switch or any front panel
key except the BAND key.
4-5-7. Memory Channel Lockout
This function allows you to specify which memory chan-
nels you wish to scan during the memory channel scan
function.
1. Press the MR key to select the Memory Channel Mode.
2. Select the Memory Channel that you wish to skip by turn-
ing the tuning control or by pressing the microphone
UP/DWN switches.
3. Press the F key for longer For longer than 1 second
than 1 second. The F indi-
cator will begin to flash.
Within 10 seconds of
pressing the F key press
the MR key. Ax will ap-
pear to the left of the
memory channel number.
This indicates the Memory
channel will be skipped
during the Memory Chan-
nel scan mode. ! i
4. Repeat steps 2 and 3 to lock out any other channels you
wish to skip.
5. To cancel the lockout, select the desired Memory Channel
as described in steps 1, 2 and 3 above. A star should ap-
pear to the left of the memory channel number. To cancel
the lock out press the F key for longer than 1 second and
then press the MR key. The star indicator should turn off.
25