Kenwood TM-701A Instruction Manual page 24

Carrier Operated Scan
don't loose the station when operators change.
following procedure.
4-5-3. Band Scan
To initiate Band Scan
1. Press the VFO key to select
the VFO mode. veo
2. Adjust the Squelch control 1°)
to the Threshold
point.
For longer than 1 second
3. Press and hold the VFO key
for longer than 1 second.
The MHz indicator will be-
gin flashing to signal the ra-
dio is scanning. Flashing
24
the current STEP selection.
5. Scan will stop on a busy channel, i.e. a station that is
strong enough to open squelch and turn on the BUSY in-
dicator.
6. You can cancel scan with any front panel key or the
microphone PTT switch.
4-5-4, Programmable Band Scan
1. For example UHF band the lower scan limit should be
stored into memory channel 15, and the upper scan limit
should be stored into channel 16.
CAUTION: —
If the frequency in memory channel 15 is equal to or higher
than the frequency stored in channel 16 scan will proceed
over the entire tuning range of the set, i.e. it will function
like the Band Scan previously described.
. Adjust the SQL control to the squelch threshold point.
. Press the VFO key to select the VFO mode.
. Select a frequency between the two programmed scan
limits.
5. Press the VFO key for longer than one second. The MHz
indicator will begin flashing as a visual reminder the tran-
sceiver is scanning.
6. Scan will begin in an upwards direction. You can change
the direction of scan by turning the tuning control or by
pressing the microphone UP/DWN switches.
7. Scan will stop whenever a signal is received that will open
the squelch of the radio.
8. Press the PTT switch or any front panel key to stop scan.
PWN)