Kenwood TM-701A Instruction Manual page 17

4. Press the CALL key within
10 seconds. A long beep
will sound and the F indica-
tor will turn off in the dis-
play. This indicates that the
lower limit has been suc-
cessfully stored in memory.
5. Now select the desired
upper tuning limit using
the MHz key and tuning
control, or microphone
UP/DWN switches.
With our example we want
the upper band limit to be
in the 145 MHz band, and
therefore dial up 145.100
MHz.
6. Press the F key for longer
than 1 second. The F indi-
cator will again begin
flashing.
7. Press the SHIFT/AL key wi-
thin 10 seconds. A long
beep will sound and the F
indicator will turn off in the
display. This indicates that
the upper limit has been
successfully stored in
memory.
For longer than 1 second
SHIETAL
Flashing
8. To
confirm that the
programming was properly
performed rotate the tuning
control or press the
UP/DWN switches. The
transceiver should not go
above or below the
programmed band limits.
. To clear both programmed
limits simultaneously you
should initialize the VFO
memory using the proce-
dures discussed on page
10. You can reprogram
either limit independently
by following the appropri-
ate instructions above.
~ 4 4000—
145.9 75~—
veo POWER
17