Table of Contents
Advertisement
3. HAE69C Mount Assembly
HAE69 is operated under unbalanced condition and could be tipped over if tripod is not secured.
Step 1. Set up tripod
Carefully remove the mount from the carrying case. The HAE69 has a 150mm base. An optional
LiteRoc tripod #8023ACC or a tri-pier #8034 may be used. Setup and level the tripod. Adjust the tripod
height. Tighten tripod locking knob to secure the tripod. Remove the Alignment Peg from the mount base
and threaded it onto the tripod head, on top of a tripod leg or between two legs depending on the latitude.
The two outside threaded holes are used for securing the mount head using Azimuth Locking Screws.
Step 2. Attach mount head
Remove the mount from the package. Retract the 2x Azimuth (Azi) Adjustment Screws from both
sides to leave ample space for the alignment peg to be fitted in between the 2x Azi Adj. Screws. Remove
the 2x Azi Locking Screws from the mount base and insert them into the opening next to Azi Adj. Screw.
Secure the mount head by tightening the Azi Locking Screws into the M8 holes on the tripod. An Allen
wrench is stored in the EQ base if needed.
Azi. Locking Screw
Figure 5. LiteRoc tripods
Azi. Adj. Screw
Alignment peg
For HAE69
Center Post
Azi. Locking Screw
9
Alignment peg
Advertisement
Table of Contents
