Port Speed (Dbm) Configuration Options - Paradyne COMSPHERE 3550 Series User Manual

Data service units
Hide thumbs Also See for COMSPHERE 3550 Series:
Table of Contents

Advertisement

COMSPHERE 3550 Series Data Service Units
Prt1( 9.6): 9.6
Next
14.4
56
Port 1 Speed . Primary data rate in kbps on Port 1. (Must be set to the same value in the remote DBM.)
14.4 to —
Select to set the port's operating rate.
1.2 kbps
Disab
Select to disable the port.
Option Verification: For all ports, the DBM verifies that the sum of the individual port speeds does not exceed the
primary aggregate speed set in Rate(Kbps) in the DBM option set. If the sum of the port speeds equals the primary
aggregate rate, an underspeed port selection is required .
Prt2( 9.6): 9.6 for MPTT; Disab for all other configurations
Next
14.4
12.0
Port 2 Speed . Primary data rate in kbps on Port 2. (Must be set to the same value in the remote DBM.)
14.4 to —
Select to set the port's operating rate.
1.2 kbps
Disab
Select to disable the port.
Option Verification: For all ports, the DSU verifies that the sum of the individual port speeds does not exceed the
primary aggregate speed set in Rate(Kbps) in the DBM option set. If the sum of the port speeds equals the primary
aggregate rate, an underspeed port selection is required.
Underspeed: Disab
Next
Disab
Prt1
Underspeed Port . Selects which port is to run slightly underspeed to allow for in-band framing and in-band secondary
channel transport, if used. If more than one port is active and the sum of the port speeds equals the primary aggregate
speed, then one synchronous port must run underspeed .
The number of bits per second used for in-band framing is 10. The in-band secondary channel transport speed is set in
2nd Chan(bps) and, if used, includes the 10 bps in-band framing. A port used for asynchronous operation may not be set
for underspeed.
NOTE: When Port Cntrl is set to DSD or Share DevA is enabled (in the MUX (Setup) option set), port speeds are only
counted once per DSD when calculating used bandwidth.
Disab
No port runs underspeed during primary operation.
Prt1 or —
Selected port runs underspeed during primary operation.
Prt2
5-28
Table 5-13

Port Speed (DBM) Configuration Options

12.0
9.6
4.8
2.4
19.2
9.6
4.8
2.4
Prt2
Prev
1.2
Disab
Prev
1.2
Disab
Prev
July 1999
3550-A2-GB20-40

Advertisement

Table of Contents
loading

This manual is also suitable for:

3551Comsphere 3550Comsphere 3551

Table of Contents