Paradyne 3610 Software Installation Manual
Dsu
Hide thumbs
Also See for 3610:
- Operator's manual (310 pages) ,
- Application manual (238 pages) ,
- User manual (112 pages)
Related Manuals for Paradyne 3610
Summary of Contents for Paradyne 3610
- Page 1 You have accessed an older version of a Paradyne product document. Paradyne is no longer a subsidiary of AT&T. Any reference to AT&T Paradyne is amended to read Paradyne Corporation.
- Page 2 P a r a dyn e 3600 Series DSU Firmware Installation Instructions Document Number 3610-A2-GZ43-20 February 1996 Firmware Version Model 3610 Firmware Requirements Installation This document describes the procedure for installing replacement firmware in a Model 3610 or 3611 Data HANDLING PRECAUTIONS Service Unit (DSU).
- Page 3 The Model 3610 DSU firmware is located on the WARNING EPROM under the front panel. To access the firmware, perform the following steps: When installing the EPROM on the DSU, ensure that the notch Procedure on the EPROM is on the right. Installing the EPROM in the opposite direction will damage 1.
-
Page 4: Powering Up The Dsu
Powering Up the DSU To verify the new firmware version: Procedure Procedure 1. Access the Status (Stat) branch from the front 1. At the rear of the DSU, insert the round end of the panel. power cable into the receptacle labeled POWER. 2. - Page 5 Model 3611 Firmware Accessing a Model 3611 DSU with MUX Installation Procedure To access the DSU to install the firmware in a 1. Remove the 3611 DSU with a MUX. The MUX Model 3611 DSU, perform the following steps: card for TDM or MCMP is attached to the DSU. Together, the two cards use two carrier slots.
- Page 6 3. Using the proper EPROM extractor tool, remove Reinstalling a Model 3611 DSU the EPROM from the DSU circuit card. Note the location and orientation of the notch at one end of the EPROM and set the EPROM aside. Reinstalling a Model 3611 DSU without MUX Procedure 1.
- Page 7 Powering Up the DSU Verify Firmware Version Procedure Power-up Routine 1. Access the Status (Stat) branch from the front When you apply power to the DSU circuit card, the panel. DSU performs a power-up routine and: 2. Select ID. Press the key until the Determines what hardware options are installed, DSU SW ver appears.