B Incoming Power Access Holes; C Access Panels; D Verifying Transformer Setting (Select Units) - Aquacal T030 Installation Manual

1.3.B Incoming Power Access Holes

1.3.C Access Panels

DANGER
Deactivate power while routing wiring to control board.
l
Units supplied with a wired plug must use a (GFCI) rated outlet. Please note, the power cord for this unit is 6.5
l
feet (198 cm) long.
Follow all National Electric Codes (NEC) and/or State and Local guidelines.
l

1.3.D Verifying Transformer Setting (Select Units)

Transformer voltage must be confirmed and set correctly depending on the measured voltage found on the
site. Incorrect settings may cause heat pump damage. The following procedure will allow the installer to
set the heat pump's transformer for the appropriate site voltage.
DANGER
Deactivate power while routing wiring to control board.
l
Units supplied with a wired plug must use a (GFCI) rated outlet. Please note, the power cord for this unit is 6.5
l
feet (198 cm) long.
Follow all National Electric Codes (NEC) and/or State and Local guidelines.
l
WARNING
The information contained in this section is intended for use by qualified technicians, familiar with electrical
l
service-industry safety standards and methods.
Failure to heed the following will result in injury or death.
Failure to heed the following will result in injury or death.
Failure to heed the following may result in injury or death.
Page - 12