Table of Contents
Advertisement
Titanium ThermoLink
1. Disconnect the plumbing to the heat pump at connection unions (removal is counter-
clockwise).
2. Allow water to drain completely from the heat pump. Expect to see a lot of water drain out at
first, and then a small amount to continue to drain out over a long period.
3. After heat pump has fully drained, partially reconnect plumbing connection unions.
4. Winterizing is complete.
5. When ready to use the heat pump again, hand-tighten connection unions. Reconnect electrical
power, and set the operating mode on the heat pump. Activate the filter pump.
2.10 Available Accessories
Accessories may be purchased through an authorized dealer of AquaCal
Condensation Drain Kit (# STK0202)
Used when condensation water flow must be directed to a
l
specific location.
Grid Flow Switch (# 0040S)
Used for automatic pool/spa thermostat switching.
l
This switch can also be used in place of the water pressure
l
switch. This may be needed when the pool/spa elevation is
higher than the heat pump. A higher elevation of the water
can cause a false signal to the heat pump; indicating water
is flowing through the heat pump when it isn't.
This kit is not to be used on applications exceeding 50 PSI
l
(345 kPa).
Liquid Blankets
An invisible liquid heat barrier designed to retain heat and
l
extend the swimming season.
AquaCal
®
recommends
l
®
Exchanger (with no Drain)
Lo-Chlor
®
Aqua Blanket
®
.
™
No Drain
products.
Page - 22
Advertisement
Table of Contents
