Using Entry Code To Access Heat Pump; Setting Entry Code Option - Aquacal GBB Series Operation Manual

1.5.e Using Entry Code to Access Heat Pump
If a user entry code has been enabled in the user menu, an entry code will be required to access heat pump
options.
PLEASE NOTE -
If the entry code has been misplaced, the heat pump will need to be reset to factory defaults.
l
After three minutes of inactivity, the heat pump's sleep mode will activate. See "Wake Up
l
Heat Pump" on page 3.
1.5.f Setting Entry Code Option
The entry code feature can prevent unauthorized temperature adjustments. This feature initiates after the heat
pump goes into the sleep mode for the first time.
NOTICE
Before enabling the entry code feature, be sure to record the code. If lost, the heat pump will require a
l
program reset to regain access. This reset may require additional configuration by the installer.
PLEASE NOTE -
A heat pump requesting an entry code is different than the control panel's sleep mode. (See
Wake Up Heat Pump on page 3 for more information.)
Page - 13
Failure to heed the following may result in damage to equipment.