Husqvarna TS 112 Operator's Manual page 28

5. If it is necessary to make a front adjustment, loosen
the locknut and turn the nut on the front link.
Note:
The front link is in the front of the product,
behind the muffler.
a) Turn the nut counterclockwise to lower the front
of the cutting deck.
b) Turn the nut clockwise to lift the cutting deck.
c) Tighten the locknut when the front adjustment is
complete.
To examine the blades
CAUTION:
balanced blades can cause damage to the
product. Replace damaged blades. Let an
approved service agent help you sharpen
and balance blunt blades.
1. Remove the cutting deck. Refer to
install the cutting deck on page 25 .
2. Look at the blades to see if they are damaged and if
it is necessary to sharpen them.
28
Damaged or incorrectly
To remove and
To replace the blades
1. Lock the blade with a wooden block.
A
B
C
2. Remove the bolt (A), the washer (B), and the blade
(C).
3. Install the new blades with the bent ends in the
direction of the cutting deck.
WARNING:
can cause objects to eject from the
cutting deck and cause serious injury.
Use only the blades given in
data on page 38 .
4. Tighten the bolts to 80 Nm.
To replace the cutting deck belt
1. Remove the cutting deck. Refer to
install the cutting deck on page 25 .
2. Remove the dirt and grass around the bearing
housings, blade pulleys and from the top surface of
the cutting deck.
3. Remove the bolt (A), the washer (B) and the idler
pulley (C).
A
B
4. Remove the cutting deck belt (D) from the blade
pulleys on the cutting deck.
5. Install a new drive belt in the opposite sequence.
Incorrect blade type
Technical
To remove and
C
2117 - 003 - 16.01.2024
D