Husqvarna TS 112 Operator's Manual page 30

WARNING:
your body, clean with soap and water.
1. Remove the oil drain hose (A) from the holder (B)
and put the oil drain hose through the gap (C).
2. Put a container below the oil drain plug.
3. Remove the dipstick.
4. Remove the end cap on the oil drain valve on the
oil drain hose and let the engine oil drain into the
container.
5. When all oil is drained, install the end cap on the oil
drain valve.
6. If the engine has an oil filter, replace the oil filter.
To replace the oil filter (TS 114) on page
Refer to
30 .
30
If you spill engine oil on
A
B
C
7. Fill the oil slowly through the hole for the dipstick.
Use an oil with viscosity that agrees with the
temperature ranges in the figure. Refer to
data on page 38 .
-20°C -10°C 0°C
SAE10W-30
SAE5W-20
-4°F -14°F 32°F
CAUTION:
types of oil.
8. Install the dipstick.
9. Discard the used engine oil.
To replace the oil filter (TS 114)
WARNING:
you spill engine oil on your body, clean with
soap and water.
1. Drain the engine oil. Refer to
oil on page 29 .
2. Turn the oil filter counterclockwise to remove it.
3. Lightly lubricate the rubber seal on the new oil filter
with new engine oil.
4. Turn the oil filter clockwise by hand until the rubber
seal is in position, then tighten a half turn more.
5. Fill the engine with new engine oil. Refer to
replace the engine oil on page 29 .
6. Start the engine and let it operate at idle speed for 3
minutes.
7. Stop the engine and make sure that there is no oil
leakage from the oil filter.
8. Fill with engine oil to make up for the oil held in the
new oil filter.
Technical
10°C 20°C 30°C 40°C
SAE40
SAE30
SAE10W-40
50°F 68°F 86°F 104°F
Do not mix different
Use protective gloves. If
To replace the engine
To
2117 - 003 - 16.01.2024