Paradyne Hotwire 6381 Install Manual page 6

7.
CONNECT TO POWER. Insert the supplied power cord's
round end into the jack labeled POWER. Plug the
transformer into an AC outlet.
When the power cord is installed, the router goes through
a power-on self-test.
the LEDs should appear after a successful test.
Installation is now complete.
If your Internet Service Provider (ISP) has instructed you to configure the Hotwire
ADSL/R Bridge/Router using the web interface, or if you would like to use the device as
a router, proceed to
Note to service provider: Each 6381 on the same subnet requires a unique IP address if
you wish to upgrade firmware or access it using the web interface.
LED Status on page 7 shows how
Configuring the Hotwire ADSL/R Bridge/Router
6
POWER
Transformer
on page 8.