- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Safety Instructions Safety Instructions WARNING : To reduce the risk of fire or electric shock, DO NOT expose this apparatus to rain or moisture. Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus.
Page 4
Safety Instructions Safety Instructions continued Safety Instructions continued 12. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart / apparatus combination to avoid injury from tip-over. 13.
Introduction Introduction Introduction Controls Controls Remote Control Sensor Power/Standby indicator Glows red in Standby mode, Glows green when the TV is turned on. Channel Buttons Volume Buttons Enter Button ENTER Menu Button MENU TV·Video Button VIDEO On/Off Button ON/OFF...
Introduction Remote Control Key Functions Remote Control Key Functions - When using the remote control, aim it at the remote control sensor on the TV. MUTE Switches the sound on or off. TV/VIDEO Selects: mode. (Refer to p.17) EXIT NUMBER buttons AUDIO (Refer to p.19)
- Note: The Kensington Security System is an optional accessory. NOTES a. If the TV feels cold to the touch, there may be a small “flicker” when when it is turned on. This is normal, there is nothing wrong with TV.
3. To connect an additional equipment, see the External Equipment Connections section. 4. Connect the power cord. 5. Close the back cover. ire Holders ire Holders - Thread, then pull the wires through the hole on the TV stand. Adjusting the TV V iewing Angle...
- If you have a 75Ω round cable, insert the bronze wire and then tighten the connection nut. If you have a 300Ω flat wire, connect the twisted wire to the antenna converter and then connect the converter to the antenna jack on the TV.
TV Setup Cable TV Setup - After subscribing to a local cable TV service and installing a converter, you can watch cable TV programming. - For further cable TV information, contact a local cable service provider. Connection 1 1. Select 3 or 4 with channel switch on cable box.
2. If your DVD only has an S-Video output jack, connect this to the S-VIDEO input on the TV and connect the DVD audio outputs to the AUDIO INPUT jacks on the TV, as shown in the figure. NOTE: If your DVD player does not have component video output, use S-Video.
Installation PC Setup PC Setup - After setup, be sure to select RGB-PC source on TV. Connections 1. Set the monitor output resolution on the PC before connecting to the TV. 2. Connect the TV to the PC with the PC cable.
Operation Operation PC Menu Options PC Menu Options - After setup, be sure to select PC source to see the PC image on TV screen. H-Position V-Position Clock Phase Auto Configure Reset OK MENU 1. Press the MENU button and then use 2.
NOTE • If you want to turn the TV off, press the on/off button located on the TV. If you intend to be away on vacation, disconnect the power plug from the wall power outlet. Menu Language Selection Menu Language Selection - The menus can be shown on the screen in the selected language.
Erased from the channel list. Favorite Channels Setup Favorite Channels Setup - Favorite Channel lets you quickly tune in up to 8 channels of your choice without having to wait for the TV to scan through all the in-between channels. Channel EZ Scan Manual prog.
• You can enjoy the cinema (the picture format of 16:9) or general TV programme through the 16:9 mode. The screen 16:9 is viewed just like that but the screen 4:3 is magnified to the left and right so that the screen 16:9 is full.
Audio Audio - This function lets you enjoy the best sound without any special adjustment because the TV selects the appropriate sound option based on the program content. 1. Use the AUDIO button to select the appropriate sound setup as shown below.
D D / E E button to select button to select button to set the hour. button to set the minutes. Auto Clock Auto TV 1 Auto Move Adjust Exit  menu..(Mountain Standard Time),...
- The TV must be in standby mode for the On-Timer to work. - If you don’t press any button within 2 hours after turning on the TV with the On-Timer function, the TV will automatically revert to standby mode.
• SNOW: If your receiver is located at the weak, fringe area of a TV signal, your picture may be marred by small dots. It may be necessary to install a special antenna to improve the picture. 2. An old, bad, or illegally recorded tape is being played.
2. Press the ENTER button to save. Key Lock Key Lock - The TV can be set up so that it can only be used with the remote control. - This feature can prevent unauthorized viewing. 1. Press the MENU button and then use 2.
V-Chip rating and categories Rating guidelines are provided by broadcast stations. Most television programs and television movies can be blocked by TV Rating and/or Individual Categories. Movies that have been shown at the theaters or direct-to-video movies use the Movie Rating System (MPAA) only.
D D / E E Then, press the button. • If is already set, enter the password requested. • The TV is set with the initial password “0-0-0-0”. 2. Setting Lock on/off: Press the button to select D D / E E...
Absence Extended Absence If you leave your TV dormant for a long time (such as a vacation), it’s a good idea to unplug the power cord to protect against possible damage from lightning or power surges. Product Specifications Product Specifications...
Troubleshooting Checklist roubleshooting Checklist roubleshooting Checklist SYMPTOMS No power No picture or sound Poor picture but good sound Poor reception Lines in picture Ghosts (multiple images) Remote control does not work. Cannot tune desired channel. CHECK THESE THINGS Is power cord plugged in ? Is television turned on ? Check batteries in remote control.
Page 28
P/NO : 3828TUL270Z(0501-REV00) Printed in Korea...