Table of Contents
Advertisement
Error Indicators
Beeper Pitch - Base Error
The base can be configured to beep at a particular pitch when an error occurs,
such as transmission problems to a host system. The beeper pitch codes modify
the pitch (frequency) of the error tone the base emits when there is an error. Default
= Low.
Number of Beeps - Base Error
The number of beeps and LED flashes emitted by the base for an error condition
can be programmed from 1 - 9. For example, if you program this option to have five
error beeps, there will be five error beeps and five LED flashes in response to an
error. To change the number of error beeps, scan the barcode below and then scan
a digit (1-9) from the
Default = 1.
Scanner Report
Scan the barcode below to generate a report for the connected scanners. The
report indicates the port, work group, scanner name, and address. To assign a
name to your scanner, refer to
Granit XP User Guide
* Low/Razz (250 Hz)
High (4200 Hz)
Programming Chart,
beginning on page 291, then Save.
Number of Base Error Beeps/LED Flashes
Menu Command
Scanner Report
Medium (3250 Hz)
Syntax, page 227.
51
Advertisement
Table of Contents
