Honeywell Granit XP 199xi Series User Manual page 100

Trigger Number
This sets the number of trigger presses required to activate the Trigger Toggle
Mode. Default = 3.
Trigger Timing
This sets the timing of the trigger presses in order to qualify as a trigger toggle,
rather than a regular trigger press. After scanning the Trigger Timing barcode, set
the time-out duration (from 50-2,000 milliseconds) by scanning digits from the
Programming Chart,
Trigger Toggle Timeout
This sets the length of time the scanner stays in trigger toggle mode before revert-
ing to scan mode. After scanning the Trigger Toggle Timeout barcode, set the
time-out duration (from 0 to 65 seconds) by scanning digits from the
Programming Chart,
Note: If this is set to 0, you must repeat the toggle sequence to return to the default
scanning mode. For example, if 2 quick trigger presses puts the scanner into
centering mode and the Trigger Timing is 0, you would have to do 2 quick presses
again to go back to the default scanning mode.
84
2 Quick Triggers
4 Quick Triggers
beginning on page 291, then Save. Default = 400ms.
beginning on page 291, then Save. Default = 5 seconds.
Trigger Timing
Trigger Toggle Timeout
*3 Quick Triggers
Granit XP User Guide