Antenna; Antenna Hook Up - Zenith HealthView H20F50DT Installation And Operating Manual, Warranty

Antenna Hook Up

Connect an off-air antenna to the HealthView TV
1
Locate the Antenna/Cable jack on the back of
the HealthView TV.
2
Connect the antenna wire that runs from the
wall to this jack, according to one of the dia-
grams shown to the right.
3
Remove the back of the optional remote and
put in two AA batteries.
4
Plug in the TV. The HealthView TV is designed
to operate on standard current, 120-volt 60
Hertz AC. Do not attempt to operate it on DC
power.
5
Go to page 11 to Auto Program the TV.
If you have a 75 ohm RF cable, then you don't need
any adapters.
A 300 to 75 ohm adapter is not included with the
Zenith HealthView TV.
Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of the TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
300 TO 75 OHM
on one end and a round opening with a wire sticking out on the other end.
ADAPTER
P A G E 6
Back of
Remote

Antenna

Flat wire
(300 ohm)
300/75 ohm
Adapter
Antenna
RF Coaxial Wire
(75 ohm)
TV Back Panel
(Expanded View)
TV Back
TV
SPKR
ANTENNA
CABLE
PILLOW
Video Speaker
SPKR
In Out
M.P.I.
PILLOW SPEAKER
Audio
In
TV Back Panel
(Expanded View)
TV Back
TV
SPKR
ANTENNA
CABLE
PILLOW
Video Speaker
SPKR
In Out
M.P.I. PILLOW SPEAKER
Audio
In
206-3491-O