7.4.1-4. Master Body Setting and Position
7.4.1-4.1 Master Body Setting
- Perform cancellation of the Initial Settings. (Refer to the service manual for the master body.)
- Reset the settings. (it is available on setup menu in user's GUI menu.)
- Set the function parameter to below setting
Setting Item
Mode dial
Aperture
Focus mode lever
Aspect Ratio
Picture size
Picture quality
Focus mode (AFS/AFF)
Photo style
Image stabilizer
Self Timer
Shutter Type
AF mode
Metering mode
ISO
White balance
Flash mode
Exposure compensation
7.4.1-4.2 Master Body Position
Place the Lens so that the center of the Checking chart comes to the center of the monitor screen of Master Body.
(1) Adjust the height of a tripod so that the center of the Checking chart is corresponding to the height of the lens.
Align the position of DSC by using a set-square and so on.
(2)
(3) Adjustment distance between the camera and Checking Chart by referring the following figure.
TELE
(Compact Checking Chart)
Left & Right chart's flame line : Meets with edge of LCD screen.
Upper & Lower chart's frame line : Out of LCD screen.
Compact Checking Chart (For TELE)
Checking Chart (For WIDE)
Setting Value
A (Aperture-priority AE mode)
Maximum aperture
(TELE: F5.6 / WIDE:
AFS/AFF
3:2
L (17M)
FINE
AFS
Monochrome
OFF
2 seconds
ESHTR (For Tele)
1 point
Multi
TELE:800 / WIDE:200
AWB
Off
0EV
About 3,000mm (TELE : H-FS14140)
About 1,100mm (WIDE : H-FS14140)
23
F3.5)
WIDE
(Checking chart SUKZ000059)
Guide line of the checking chart comes
to upper edge of the LCD screen
Guide line of the Chart