Antenna With Vcr - Zenith Concierge H19D34Y Installation And Operating Manual, Warranty

Antenna With VCR Hook Up
Connect an off-air antenna and VCR to the Concierge TV
Locate the Antenna/Cable jack on the back of
1
the VCR.
2
Connect the antenna wire that runs from the
antenna, according to one of the diagrams to
the right. Make other connections as needed.
3
Remove the back of the remote and put in two
AA batteries.
4
Plug in the TV. Do not plug it into a switched
outlet. The Concierge TV is designed to operate
on standard current, 120-volt 60 Hertz AC. Do
not attempt to operate it on DC power.
5
Go to page 11 to Auto Program the TV.
No A/V cables are included with the TV.
Model H25D39Y is not equipped with an MPI card.
P A G E 8
back of
remote
Antenna
Flat wire
(300 ohm)
TV Back
ANTENNA
CABLE
Super
Port
VIDEO SPEAKER
M.P.I.
IN OUT
AUDIO
IN
TV Back Panel
(Expanded View)
TV Back
ANTENNA
CABLE
Super
Port
VIDEO SPEAKER
M.P.I.
IN OUT
AUDIO
IN
TV Back Panel
(Expanded View)
VCR Back AV Panel
In
300/75 ohm
Adapter
Out
Antenna
VCR Back
VCR Back AV Panel
In
RF Coaxial Wire
(75ohm)
Out
A/V Cables
Not included
with TV
206-3490-O
VCR Back
output
switch
3 4
Video Audio
output
switch
3 4
Video Audio