Table of Contents
Advertisement
Hook Up Your Cable (CATV) to the TV
Connect cable service to the Concierge TV
Locate the Antenna/Cable jack on the back of
1
the Concierge TV.
Connect the cable that runs from the wall
2
directly to this jack, according to the diagram
to the right.
Remove the back of the remote and put in two
3
AA batteries.
Plug in the TV. Do not plug it into a switched
4
outlet. Your Concierge TV is designed to oper-
ate on household current, 120-volt 60 Hertz
AC. Do not attempt to operate it on DC
Current.
5
Go to page 11 to Auto Program the Concierge
TV.
If you're using a cable box, leave the TV on
channel 3 or 4 and use your cable box to
change channels.
Remember, when screwing RF cables onto jacks,
clockwise tightens, and counterclockwise loosens
If you're using a cable box, Auto Program might
only find the channel your cable service is on
(usually channel 3 or 4).
Model H2539Y does not have the MPI card.
206-3490-O
back of
remote
TV back
Cable TV
wall jack
RF coaxial wire (75 ohm)
Super
Port
TV back panel
(expanded view)
Cable TV
wall jack
Cable box
In
output
Out
switch
3 4
RF coaxial wire (75 ohm)
TV back panel
(expanded view)
ANTENNA
CABLE
VIDEO
SPEAKER
IN
OUT
M.P.I.
AUDIO
IN
TV back
ANTENNA
CABLE
Super
Port
VIDEO
SPEAKER
IN
OUT
M.P.I.
AUDIO
IN
P A G E 7
Advertisement
Table of Contents
