Table of Contents
Advertisement
Hook Up Your Antenna to the TV
Connect an off-air antenna to the Concierge TV
1
Locate the Antenna/Cable jack on the back of your
Concierge TV.
Connect the cable that runs from the wall directly to
2
this jack, according to the diagram to the right.
3
Remove the back of the remote and put in two AA bat-
teries.
4
Plug in your TV. Do not plug it into a switched outlet.
Your Entertainment Machine is designed to operate on
standard current, 120-volt 60 Hertz AC. Do not attempt
to operate it on DC Current.
5
Go to page 11 to Auto Program the TV.
If you have a 75 ohm RF cable, then you don't need
any adapters!
A 300 to 75 ohm adapter is not included with the
Zenith Concierge TV.
Model H25C39Y does not have the MPI card.
Mini glossary
75 OHM RF CABLE
The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
300 TO 75 OHM
on one end and a round opening with a wire sticking out on the other end.
ADAPTER
P A G E 6
back of
remote
TV back
Antenna
Flat wire
(300 ohm)
ANTENNA
CABLE
Super
Port
M.P.I.
TV back panel
300/75 ohm
(expanded view)
Adapter
TV back
Antenna
RF coaxial wire
ANTENNA
CABLE
(75 ohm)
Super
Port
M.P.I.
TV back panel
(expanded view)
VIDEO
SPEAKER
IN
OUT
AUDIO
IN
VIDEO
SPEAKER
IN
OUT
AUDIO
IN
206-3490-O
Advertisement
Table of Contents
