Hook Up Your Antenna To The Tv - Zenith A27B41 Operating Manual

P A G E 4 I N S TA L L AT I O N

Hook Up Your Antenna to the TV

Connect an
antenna
to your
Entertainment
1
Machine.
2
3
4
Mini glossary
75 OHM RF CABLE
300 TO 75 OHM ADAPTER
S TA N DA R D
Hook up your Entertainment
Machine, see diagrams at right.
Remove the back of the remote
and put in two AAA batteries.
back of
remote
Plug in your TV. Do not plug it
into a switched outlet.
Go to page 10 to Auto Program
your Entertainment Machine.
If you have a 75 ohm RF cable,
then you don't need any adapters!
Remember, when screwing RF
cables onto jacks, clockwise tight-
ens, and counterclockwise loosens.
A 300 to 75 ohm adapter is not
included with your Zenith
Entertainment Machine.
The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an
inch long with two screws on one end and a round opening with a wire sticking out on the other end.
Antenna
Flat wire
(300 ohm)
300/75 ohm
Adapter
Antenna
RF coaxial wire
(75ohm)
TV back
TV back panel
(expanded view)
Antenna
/ Cable
TV back
TV back panel
(expanded view)
Antenna
/ Cable
3374-O