Lincoln Electric 10372 Service Manual page 126

F-62
G S SOLENOID REMOV L
FIGURE F.17 — G S SOLENOID REMOV L
PROCEDURE
1. Remove input power to the wire feeder.
2. Using the 3/8 in. nutdriver, remove the
cover from the wire feeder.
3. Locate the gas solenoid on the rear
panel of the wire feeder. Refer to
Figure F.17.
4. Using the 3/4 in. wrench, remove the
external brass fitting.
5. Carefully remove the two leads from
the solenoid.
6. Remove the gas hose from the sole-
noid.
7. Using the 5/16 in. nutdriver, remove
the two screws mounting the solenoid
to the rear case panel.
8. Carefully remove the gas solenoid from
the wire feeder.
TROUBLESHOOTING ND REP IR
GAS
HOSE
POWER W VE 455/POWER FEED 10
ND REPL CEMENT ( ontinued)
ND REPL CEMENT.
MOUNTING
SCREW
BRASS
FITTING
GAS
SOLENOID
HOSE
FITTING
INST LL TION
1. If a new solenoid is to be installed, it
may be necessary to remove the hose
fitting from the "old" solenoid and
install it into the new solenoid using the
1/2 in. wrench.
2. Place the gas solenoid into the wire
feeder and secure it to the rear case
panel using the two 5/16 in. mounting
screws.
3. Install the gas hose onto the solenoid.
4. Connect the two electrical leads to the
gas solenoid.
5. Install the external brass fitting onto the
gas solenoid using the 3/4 in. wrench.
6. Install the wire feeder cover with the
3/8 in. nutdriver.
F-62