How To Set Air Quality Level Color; Forced Operation; Auto Restart Function - LG AMNW09GTUC0 Owner's Manual

How to set Air quality level color

1
With the button pressed, press the
reset button.
+
2 By using the or
code and Setting value.
Function code
Setting code

Forced Operation

Operation procedures when the remote control can't be used.
Press the tact switch (forced operation) for 2 seconds.
If you want to stop operation, press again the tact switch.
In case the power comes on again after power failure on the
forced operation mode, the operating conditions are
automatically set as follows:
During forced operation, the initial mode continues.

Auto Restart Function

In case the power comes on again after a power failure, auto restarting operation is the function to operate procedures
automatically to the previous operating conditions.
button, set function
3
Press the button toward the indoor unit
1 time. Each countries have different standards
for indicating Overall air quality. Please refer to
table below.
Value Step
Type1 4step
(1beep) (For Korea)
Type2 4step
(2beep) (For Global)
Type3 6step
(3beep) (For China)
4 Reset the remote controller to use the general
operation mode.
NOTE
• The feature may be changed according to the type
of model.
• Some functions may not be supported, depending
on the model.
Owner's Manual 21
Operating Instructions
Overall Air Quality
Good/Moderate/Unhealthy/
Poor
Good/Moderate/Unhealthy/
Poor
Good/Moderate/Unhealthy/
Poor/ Very Poor/ Severe
Forced operation
(Tact switch)