LG AMNW09GTUC0 Owner's Manual page 25

Cleaning the PM1.0 Sensor
PM1.0 Sensor
1. As shown in the figure below, put your finger in
the indicator.
2. Open the front panel and lower the PM1.0
Sensor case as shown in the figure below.
3. Once the PM1.0 Sensor case is lowered all the
way, turn the PM1.0 Sensor case to secure it as
shown in the figure below.
Maintenance and Service (With Air Purifier)
4. Open the PM1.0 sensor cover on the side of the
case.
5. Use a slightly wet cotton swab to wipe dust off
the lens, and then use a dry swab to remove the
moisture.
6. Close the PM1.0 Sensor case cover, then install
the PM1.0 Sensor case in its original position.
!
WARNING
• For safety, turn off the main power switch.
• Be careful not to drop the product when removing
the PM1.0 Sensor corner cover.
• Be careful of falling accidents when cleaning the
PM1.0 Sensor.
NOTE
• It is recommended to clean it every six months.
(assuming 8 hours of daily use)
• PM1.0 Sensor is only included with Air purification
panel.
• The feature may be changed according to the
type of model.
• Some functions may not be supported, depending
on the model.
Owner's Manual 25