Table of Contents
Advertisement
Available languages
Available languages
OPERATION INSTRUCTIONS
Place the fan on a safe, flat surface where it can not fall or be pulled by the cord.
Adjust the desired speed by pulling the chain switch at the back of fan (A1).
0
Stop
The fan comes with an additional oscillation function.
Turn the oscillation function on by pushing the oscillation button down (A2)
To change the angle of the fan, loosen the angle adjuster, and then tilt the protective screen up or
down and finally retighten the angle adjuster (A3)
A1
CARE AND MAINTENANCE
Test GFCI (Ground Fault Circuit Interrupter) plug BEFORE EACH USE.
Plug GFCI into power outlet. Press RESET button. Indicator should turn red.
Press TEST button. Indicator should turn off. GFCI plug is tripped.
Press RESET button again for use. DO NOT USE FAN IF ABOVE TEST FAILS.
Call customer service for assistance.
Misting Nozzle Maintenance. If the misting nozzles become clogged, remove them from grille and wash
them with water. Use a non-metallic brush to scrub them if necessary, if the obstacle still exists, use the
replacement nozzle or contact the customer service for assistance. Never clear the nozzles with pins
or other sharp objects which may result in damage.
1
Low
2
A2
indicator
nozzle
Medium
3
RESET button
TEST button
5
High
A3
Advertisement
Table of Contents
