How To Clean The Brushroll And Cover - Eureka NEW400 Series Owner's Manual

How to clean the brushroll and cover

1 2
CAUTION
!
Pull up
Never operate vacuum cleaner without
cover in place.
1. To remove the brushroll cover grasp the
release button and pull up and forward.
3
4
2. Remove brushroll by pulling up on the tab
located on the left side.
3. Rinse brushroll and brushroll cover.
Use brushroll cleaning tool to help remove debris
and her on the roller.
4. Wipe the brushroll chamber thoroughly to
remove any debris.
5. Put the brush roll upright in the drying stand, let
your brush roll and cover dry thoroughly for 24 hours
before reassembling.
Note:
The brushroll, brushroll cover, dirty water tank,
clean water tank, lids and filters are not
dishwasher safe.
Please follow cleaning instructions in this manual.
6. Install brushroll by inserting the right end of the
Handle end
roller into the right side or the floor nozzle. Then
insert by aligning the tab on the left side with the
slot and pressing into place.
7. To reinstall the brushroll cover, tilt the window
back and align both tabs on the lower edges of the
cover with the slots on the floor nozzle then push
in and downwards until it clicks into place.
Driven wheel
Machine Storage
Store the machine on its base in a dry, protected
area. Ensure machine is not exposed to freezing
temperatures or internal components could be
damaged and warranty will be void.
11
www.eureka.com