Using Self-Cleaning Function; Charging The Machine - Eureka NEW400 Series Owner's Manual

Using Self-Cleaning Function

Do not remove the dirty water tank until after using the self-cleaning function as
this will allow remaining debris under the brushroll and in the tube to be sucked
into the dirty water tank.
Self-cleaning Key
Wall
CAUTION
!

Charging the machine

1.Once cleaning is completed, remove brush roll, brush roll
cover and filter, rinse them and allow to dry throughly.
2.Wipe the base dry and place the machina on the base.
3.Insert the charging end of the adapter into the charging port
(as shown in the figure), and connect to the power supply.
The ON/OFF button indicator color will change with the power
level increasing during charging.
4. It takes approximately 5 hours to fully charge the unit.
Charging port
The ON/OFF button blue indicator will go out.
5. When charging, keep it close to the corner of the wall to avoid
tripping and other injuries.
After you are done cleaning, put the machine on the base, press
and hold the self-clean button for about 3 seconds, and the
machine starts self-cleaning, which will run for 60 seconds.
After self-cleaning, empty and clean out the dirty water tank. To
stop the self-cleaning function in advance, press the Self-clean
button or the ON/OFF button.
Note:
1. Place the machine on the base when self-cleaning to avoid
injuries from tipping.
2. There will be a 3 second delay when the machine stops
self-cleaning.
3. For better cleaning of the brush, the side walls of the suction
port and the pipes, a large volume of water is used, and it is
normal for a small amount of water to be left in the base when
the self-cleaning is finished.
www.eureka.com
9