Advertisement
2.1
Transport mode
2.2
Diagnostics connector
2.3
Unpacking and setting up the vehicle
This vehicle was blocked for transport in the software.
To operate the vehicle, the vehicle electronics must be enabled.
This process is conducted during initial setup in KTM Dealer.net.
Enabling ensures that the initial setup in KTM Dealer.net is docu-
mented.
Enabling can be performed either temporarily, e.g. for a test ride,
or permanently for vehicle handover.
Info
Make sure that the vehicle is permanently enabled before
H02712-01
handing it over to the customer.
Diagnostics connector
Info
As soon as the diagnostics tool is connected, the service
hourmeter starts running.
Before longer diagnostic sessions, unplug the service
hourmeter behind the start number plate.
A01108-10
–
Remove the box and the plastic packaging.
Guideline
To avoid damaging the vehicle while setting it up, do
not remove the protective film on each component until
installing the component, and leave it on the vehicle until
work has been completed.
–
Remove the separate enclosure and unpack it. Check that the
scope of supply is complete using the enclosed packing list.
F01082-01
Info
The procedure for missing components is described in
the Customer Service Manual.
–
Have a lift stand available.
Lift stand (78129955100)
–
Carefully loosen and remove tie down
brackets on the left and right.
Info
An assistant prevents the motorcycle from falling over.
–
Remove screws
right.
F03419-10
1
is located under the seat.
1
from the footpeg
2
from the footpeg brackets on the left and
SETUP 2
3
Advertisement
