The Chorus Parameters - Yamaha VL70-m Owner's Manual

The Chorus Parameters

The VL70-m chorus stage actually includes a number of modulation-type effects that can be used
to give your sound extra animation and life.
Type
• Chorus Type
• Settings: NO EFFECT, CHORUS 1, CHORUS 2, CHORUS
3, CELESTE 1, CELESTE 2, CELESTE 3, FLANGER 1,
FLANGER 2, SYMPHONIC, PHASER
Selects the chorus type, or "NO EFFECT" if no
chorus effect is required. Refer to the separate
"List Book" for brief descriptions of each of the
chorus types.
Type-Specific Chorus Parameters
• See separate "List Book"
Each of the chorus types, selected via the "Type"
parameter, above, has a different set of parameters
that specify the actual chorus sound. Refer to the
separate "List Book" for information on the
individual parameters for each chorus type.
Cho Pan
• Chorus Pan
• Settings: L63 ... C ... R63
Sets the pan position of the chorus sound — i.e.
the perceived position of the chorus sound within
the stereo sound field. A setting of "L63" sets the
chorus sound full left, "R63" sets the sound full
right, and "C" places the sound in the center.
Intermediate settings pan the chorus sound to
corresponding positions in the stereo sound field.
SendCho Rev
• Chorus-to-Reverb Send Level
• Settings: 000 ... 127
Sets the amount of signal sent from the output of
the chorus effect stage back to the input of the
reverb effect stage (see diagram on pages 86 and
87). The higher the value, the more chorus signal
is sent to the reverb stage. If this parameter and the
PLAY mode "ChoRtn" parameter are both set to
values higher than "001", the output of the chorus
stage will be sent in corresponding amounts to the
input of the reverb stage and the main outputs.
Effects & Effect Editing
91